Re: [FW1] NAT question

[Anil Bhelkar <anilbh@hclinsys.com>]

    [ The following text is in the "iso-8859-1" character set. ]
    [ Your display is set for the "US-ASCII" character set.  ]
    [ Some characters may be displayed incorrectly. ]


this is how NAT is suppose to work.
regards

anil bhelkar
anilbh@hclinsys.com

This communication is for the exclusive use of  the intended receipient/s
and shall not attach any liability on the originator. It may contain
information which is confidential and legally priviledged and the same shall
not be used or dealt with by any third party in whatsover manner.
----- Original Message -----
From: Rajesh Bandar <rajesh@ilanet.slnsw.gov.au>
To: <fw-1-mailinglist@lists.us.checkpoint.com>
Sent: Wednesday, November 01, 2000 9:50 AM
Subject: [FW1] NAT question


>
> Hi,
>
> I am running Cgeckpoint Firewall ver 4.0 on a solaris 2.6 machine. I need
to
> configure NAT in such a way if anyone from our internal network accesses
the web
> server on DMZ, it (web server on DMZ) should see the source IP address. At
the
> same time if any one acceses internet from our internal network,
destination
> server should see only one IP (translated IP). Is it possible to
configure. Any
> help would be appreciated.
>
> Thanks,
> Rajesh.
>
>
>
>
============================================================================
====
>      To unsubscribe from this mailing list, please see the instructions at
>                http://www.checkpoint.com/services/mailing.html
>
============================================================================
====



================================================================================
     To unsubscribe from this mailing list, please see the instructions at
               http://www.checkpoint.com/services/mailing.html
================================================================================