[FW1] stateful table between two firewall 4.1 modules

["[iso-8859-1] Kälin Christian (Softec)" <Christian.Kaelin@softec.ch>]

    [ The following text is in the "iso-8859-1" character set. ]
    [ Your display is set for the "US-ASCII" character set. Some ]
    [ characters may be displayed incorrectly. ]


'm currently trying to set up a state synchronization between the gateways
in the cluster. Now I'm not shure what steps I have to take that this will
work. I found some information in the help file of the 4.1 firewall
management station. I also found that I have to configure the sync.conf file
in the Firewall directory.. Are there any white papers arround to do this..


On each FireWall Module, the $FWDIR/conf/sync.conf file lists the other
FireWall Modules (in the form of IP addresses or resolvable names) to which
this FireWall Module sends its state information. A control path must be
established between all the FireWall Modules (using the fw putkey command),
if one does not already exist. When one FireWall Module goes down, the other
FireWall Modules take over after the routing is re-configured.

Kind regards

Christian Kaelin
Softec Integrations AG
Switzerland



----------------------------------------------------------
Christian Kälin          Mail : christian.kaelin@softec.ch
SOFTEC Integrations AG   WWW  : http://www.softec.ch
Bahnhofstrasse 3         Tel  : +41 (0)41 741 88 35	
CH-6312 Steinhausen      FAX  : +41 (0)41 741 20 14	
----------------------------------------------------------




================================================================================
     To unsubscribe from this mailing list, please see the instructions at
               http://www.checkpoint.com/services/mailing.html
================================================================================