[FW1] NAT not working

[Karen Cochran <Karen.Cochran@vistait.com>]

Currently I have a CheckPoint Firewall-1 installed on a Windows NT 4 server.
NT Service Pack 4 has been applied as well as the quick fixes from
Microsoft. I started with ChekPoint's Service Pack 4 installed. Then I
uninstalled it and went back to ChekPoint's Service Pack 2. I have since
uninstalled Service Pack 2 so only the original application should be
installed. The firewall can surf the internet and ping/view the internal
network in any of these senerios. The internal network is configured with a
10.0.0.0 Mask 255.0.0.0 addressing. I want to NAT the internal users with a
single hide address. I can not seem to NAT out to the internet either with
static or hide for either a single system, the internal network or an
address range defined.

I have tested the router and it will allow for the valid ip I am trying to
access the internet. My only rule at this time is:
ANY ANY ANY Accept.

IP forwarding is enabled.

I have tried cutting down the size of the internal network to a single class
C. This did not work.

At this time I have 2 NIC's - one to the router and one to a hub with a
single workstation off it. I have defined the firewall itself. I have tried
defining the network and also defining the workstation (2 different
senerios) and neither worked.

HELP! I am stumped!


================================================================================
     To unsubscribe from this mailing list, please see the instructions at
               http://www.checkpoint.com/services/mailing.html
================================================================================