[FW1] Cisco ACLs

[Joerg Oertel <Joerg.Oertel@pallas.com>]

Dear listmembers,

is anyone using the router module of FW-1?

I'm trying to set up rules, which should be installed on a Cisco router.
After defining the rules I can verify and view the ACL as FW-1 creates it.

Two questions at this point:

1. Is it possible to print the ACL?
2. FW-1 is set up to bind the ACL inbound to the interfaces.
   How can I FW-1 that this ACL is not applicable for Eth0 of the router?
   (it really makes absolutely no sense) The router object is defined with 3
   interfaces: Serial0, BRI0 and Eth0. Deleting Eth0 from that object might
   help, but I think this is not the clean way...
   
Many thanks IA

Joerg




// pallas  GmbH  ............  Joerg Oertel  ...........
   Hermuelheimer Str. 10       Analyst                   
   D-50321 Bruehl, Germany     Joerg.Oertel@pallas.com           
                               phone  +49-(0)2232-1896-0 
   http://www.pallas.de        fax   +49-(0)2232-1896-29
........................................................



================================================================================
     To unsubscribe from this mailing list, please see the instructions at
               http://www.checkpoint.com/services/mailing.html
================================================================================